Vaisala HMT360Series Guía de usuario descargar pdf (Pagina 50)

User’s Guide ______________________________________________________________________

48 ___________________________________________________________________ M010056EN-J

Selecting Analog Outputs

You can select the output quantities for channels 1 and 2 by turning the

Calibration Enabled/Disabled DIP switch of the transmitter to position

Enabled (up) and the three output selection DIP switches to position

special (all up).

Press button C on the display cover: text "SCAL" appears on the display.

Then press button E until the following display appears:

0505-288

The characters on the second line of the display in this menu correspond to

the quantities according to the table in section Selecting Output Quantities

on page 47.

Select the quantity for Ch 1 with buttons Up and Dn and acknowledge the

selection with button E.

If the transmitter is equipped with two analog channels, select the quantity

for Ch 2 in the same way, for example:

0505-289

Press button C to exit the display command mode or continue by setting

the pressure.

NOTE

Remember to restore the DIP switch settings.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 96 97

Sin comentarios

Vaisala HMT360Series Guía de usuario Pagina 50