Vaisala PTB210 SERIES Manual de instrucciones descargar pdf (Pagina 111)

26 CONTENTS

Setting of Measurement Parameters

Before using the barometer you have to set up the parameters. The following

commands will give you an overview in terms of possible measurement settings.

To check the actual settings use ?<cr>.

To set the number of measurements performed in one minute use the com-

mand:

.MPM.xxxx<cr>

• xxxx = number of measurements per minute (6...4200)

To set the number of measurement points that are used for calculating

an average pressure reading use the command:

.AVRG.xxx<cr>

• xxxx = number of measurements (not a moving number) of which the

average is calculated (0...255)

NOTE: Make sure to reset the barometer with the command .RESET<cr>

to activate the new settings. The settings can be checked with the

command ?<cr>.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 136 137

Sin comentarios

Vaisala PTB210 SERIES Manual de instrucciones Pagina 111