Vaisala HMP60 Guía de usuario Pagina 66

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 73
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 65
User's Guide _______________________________________________________________________
64 ___________________________________________________________________ M211060EN-F
Problem or Message
Likely Causes and Solutions
The probe is not responding
to any serial commands.
- Disconnect the USB cable from the probe and
retry. If your probe is in the analog output mode,
press ENTER a few times immediately after
connecting the USB cable.
- Try the ?? command in case the probe is in
POLL mode, open the line using OPEN
command if necessary.
- Check your serial line settings and cable
connections.
The following error is active:
- Voltage error
- Operating voltage out of range. Correct voltage
and reset probe.
Any check sum error is active.
For example:
- Program flash check sum
error
- Parameter flash check sum
error
Internal error. Perform the following steps:
1. Return the probe to factory settings using the
FRESTORE command. Check again.
2. If the error is still active, contact Vaisala
technical support.
The following error is active:
- Frequency measurement
outside the permissible
value range
- Check for condensation on the probe and
sensor. Allow the probe and sensor to dry.
If the error is still active, there may be a problem
with the electronics. Contact Vaisala technical
support.
Technical Support
For technical questions, contact the Vaisala technical support by e-mail at
helpdesk@vaisala.com. Provide at least the following supporting
information:
- Name and model of the product in question
- Serial number of the product
- Name and location of the installation site
- Name and contact information of a technically competent person who
can provide further information on the problem.
For contact information of Vaisala Service Centers, see
www.vaisala.com/services/servicecenters.
Vista de pagina 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 72 73

Comentarios a estos manuales

Sin comentarios