Vaisala PTU300 Guía de usuario Pagina 106

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 186
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 105
USER'S GUIDE____________________________________________________________________
104 _________________________________________________________________ M210796EN-E
Table 31 Selection of Output Modes
Mode Output Available Commands
STOP Only with the SEND command All (default mode)
RUN Automatic output Only command S
POLL Only with the SEND [addr]
command
Use with RS-485 buses, see
Operation of the RS-485 Module
on page 125.
SEND One message at power-up.
Selected output mode will be activated after power outages.
INTV
Use the command INTV to set the outputting interval for the RUN mode.
INTV [xxx yyy]
where
xxx
= Output inverval (0 ... 255). 0: the fastest possible output rate.
y
yy
= Unit (s, min or h)
Example:
>INTV 10 min
Output intrv. : 10 min
>
ECHO
Use the command ECHO to set the user port echo. The command either
enables or disables echo of characters received.
ECHO [x]
where
x = ON (default) or
= OFF
NOTE
You can use the SERI, SMODE, INTV and ECHO commands to
change/view the user port settings even if you are currently connected to
the service port.
Vista de pagina 105
1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 185 186

Comentarios a estos manuales

Sin comentarios