Vaisala Hydromet Data Collection Platform Manual de usuario Pagina 270
- Pagina / 384
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
User's Guide ______________________________________________________________________
268 _________________________________________________________________ M210933EN-C
Parameters for virtual COM port configuration are presented in Table
49 on page 268.
Table 49 Virtual COM Port Parameters
Parameter Use Note
Service connection
enabled
Accept service connection from this
port.
If service connection is required,
there should be at least one
communications interface (both
logical and physical) with
incoming connections enabled.
The option Accept incoming
must also be selected for the
virtual COM port.
Max idle time [s] If no commands are issued through
the open service port during this
time, the port will be closed
automatically.
The idle time is configured in
seconds.
Max scrap chars Maximum number of "scrap"
characters without <CR> to accept
before automatically closing the open
service connection.
Used to reject interference
caused by, for example, line
disturbance or malfunctioning
devices.
Service connection trigger,
open action, close action
Target component and action
identifiers to trigger when service
connection is opened or closed.
Local port number Number of the local TCP port. Used only for incoming (passive)
connections. The local port
number must be unique for each
virtual COM port accepting
incoming connections.
Inactivity timeout Time in seconds for which
connection is kept open with no
traffic.
TCP keepalive TCP keepalive transmission interval
in seconds.
Ensures connection status. If
three attempts fail, the connection
will be closed. Generates
"dummy" traffic through an open
connection, thus preventing idle
timeouts that may exist, for
example, in GSM modems. The
connection is closed if four
consecutive transmission
attempts fail.
Enable Telnet protocol Enable support for Telnet escape
sequence decoding and negotiation.
Virtual COM port does not provide
full Telnet functionality, but it
provides handling for certain
escape sequences to enable
binary file transfer.
- USER'S GUIDE 1
- Table of Contents 3
- CHAPTER 4 5
- CHAPTER 5 7
- CHAPTER 6 8
- APPENDIX B 10
- List of Figures 11
- List of Tables 17
- GENERAL INFORMATION 21
- Platform Documentation 22
- Version Information 24
- Related Manuals 24
- ESD Protection 26
- Recycling 27
- Regulatory Compliances 27
- Trademarks 27
- License Agreement 27
- Warranty 29
- Cellular Modems 34
- 0410-009 35
- Supported Protocols 36
- UHF Radio Modem 37
- UHF Repeater Function 38
- UHF Antenna 39
- 0407-013 40
- 0105-035 42
- GOES Crossed Yagi Antenna 44
- CONFIGURING MODULES AND 45
- Configuring Optional Hardware 51
- Digital I/O Module 51
- Digital Outputs 52
- 0711-113 53
- Converter 55
- 0711-115 56
- 0711-117 58
- 0711-119 60
- Configuring Sensors 62
- Vaisala Weather Transmitter 62
- 0711-130 64
- 0711-133 67
- 0711-135 71
- 0711-137 73
- 0711-138 75
- 0711-139 77
- Variables in Reports 80
- 0711-143 81
- 0711-144 83
- Leaf Wetness Sensor 85
- Fuel Moisture Sensor 87
- Soil Moisture Sensor EC-5 88
- 1007-032 89
- 1007-033 90
- NMEA GGA Receiver 92
- Gauge VRG101 94
- Probe HMP155 94
- 1007-028 95
- Digital Barometer PTB330 97
- Sensor DSC111 98
- Vaisala Remote Road Surface 99
- Temperature Sensor DST111 99
- 1007-036 100
- Barometer Module BARO-1 102
- 1007-024 103
- 0606-083 105
- 0802-149 107
- Figure 57 Configuring WMT700 109
- Physical Interface 111
- Data Acquisition Methods 112
- Configuring Sensor Interface 115
- 0711-147 116
- Interface 118
- Serial Sensor Interfaces 119
- Ceilometers 122
- Digital Barometer 124
- Ultrasonic Wind Sensor 125
- Wind Transmitters 126
- GARMIN GPS35-PC GPS Receiver 131
- CONFIGURING TELEMETRY OPTIONS 133
- Minimum System Requirements 134
- Hardware Configuration 134
- I/O Connection 135
- Modem Control Parameters 136
- Modem Commands 137
- Disconnect 139
- Shutdown 139
- Excitation Delay 140
- Dial Attempts 142
- Send Delay 142
- Disconnect Delay 142
- Inactivity Timeout 142
- Use Verbose Modem Responses 143
- Answer Incoming Calls 143
- Quote SMS Numbers 145
- Extra Op. Info to COM0 145
- Check Connect in Datamode 145
- Inbound Message Handling 146
- Common Configurations 147
- PSTN-Dependent Configurations 148
- GSM-Dependent Configurations 149
- GPRS Modem -Dependent 150
- Configurations 150
- Application Alternatives 150
- Answering Incoming Calls 151
- SMS Polling 151
- Service Operation 151
- 0711-162 152
- ORBCOMM Interface 154
- Configuring ORBCOMM 155
- Communicator 155
- 0711-163 156
- Linking Reports 159
- Output Variables 159
- GOES Interface 161
- GOES Satellite Transmitters 161
- Configuring GOES Satellite 162
- Transmitter 162
- Device Configuration 163
- 0711-166 164
- Pseudo-Binary Report Format 169
- 0711-165 170
- Transmitter with AWS Client 175
- Software 175
- Transmitter Configuration 176
- Transmissions 179
- Troubleshooting GOES 180
- Transmission 180
- Forced Transmission 182
- Meteosat Interface 183
- Autotrac Interface 184
- 0711-168 185
- 0711-095 187
- Configuring Communications 189
- Formatting Report 190
- Iridium Interface 191
- 0711-170 192
- 0711-172 194
- SCD/ARGOS Interface 197
- HAL2 in Lizard Setup Software 197
- HAL2 exit 200
- Remote Maintenance Commands 201
- Command example: 202
- CONFIGURING TCP/IP-BASED 203
- TELEMETRY 203
- Secondary 204
- Network Warnings and Errors 205
- Communication Devices 206
- Common Modem Parameters 208
- Null Modem 210
- GPRS-IP Modem 211
- PSTN-IP Modem 212
- Communication Interfaces 213
- Interface Configuration 213
- Interfaces 215
- Alternative Interfaces 216
- 0710-059 217
- Authentication 219
- 0710-069 220
- 0906-026 222
- 0906-073 224
- Command hostset 226
- TCP/IP-Based Services 228
- FTP Client 228
- 0811-027 229
- Sending Reports 232
- Sending Log Files 235
- NTP Client 237
- E-Mail (SMTP) Client 240
- 0906-005 241
- Sending E-Mail Messages 244
- HTTP Client 247
- Sending Messages with HTTP 248
- 0906-056 250
- Reading Information 252
- HTTP Authentication 254
- Proxy Servers 254
- HTTP Server 255
- Table 42 on page 254 256
- Creating HTML Reports 257
- 0804-017 258
- 0803-057 260
- Dynamic DNS Client 262
- Setup Management 264
- 0906-063 265
- Command setupupdate 268
- Virtual COM Ports 269
- 49 on page 268 270
- Remote Host Configuration 272
- Enabling Physical Connection 274
- 0710-066 275
- 0710-068 277
- Configuring Generic IP Modem 279
- 0710-071 282
- Parameter Use 285
- SMS Handling 286
- 0901-007 288
- 0811-020 291
- 0811-022 293
- Commands for Parameter Sets 295
- Command netif 296
- Command ipconfig 297
- Command ping 297
- Command net 298
- Command ftp 300
- Command ntp 301
- Application Examples 302
- GPRS Connection 302
- 0803-096 303
- 0710-112 305
- 0710-114 307
- 0710-115 309
- 0803-104 310
- Connection 312
- 0710-116 313
- 0710-118 316
- 0803-109 316
- 0803-112 320
- 0803-113 320
- 0710-121 323
- 0710-123 325
- 0710-125 327
- 0710-127 329
- 0906-058 330
- TECHNICAL SUPPORT 337
- TECHNICAL DATA 339
- Communication Modules 340
- 0903-023 341
- 1006-101 343
- 1006-103 345
- Digital I/O Module QMI118 347
- Outputs) 348
- Fixed Line Modem DMX501 349
- Leased-Line Modem 351
- GSM/GPRS Modem 351
- ORBCOMM Satellite Transceiver 352
- GOES Satellite Transmitter 352
- Vaisala WA15 Set Sensors 353
- 0412-024 354
- 0412-025 354
- Specifications 356
- PSTN Modem DXM421 356
- Leased Line Modem DXL421 357
- Radio Modems 360
- LEGACY ITEMS 365
- 0802-106 366
- 0802-107 368
- Destination 370
- User Information 370
- Initialization String 371
- Connection Open Command 372
- DNS IP Address 372
- ISP User Information 373
- Use Passive Mode FTP 373
- Log File Sending with FTP 374
- COM Server Unit 376
- GSM 7-BIT CHARACTER SET 379
ASROCK P55 PRO/USB3 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Motherboards ASROCK P55 PRO/USB3.
Wir stellen 1 PDF-Handbücher ASROCK P55 PRO/USB3 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Comentarios a estos manuales