Vaisala DMP248 Manual de servicio Pagina 70

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 145
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 69
OPERATING MANUAL_______________________________________________________________
64 _____________________________________________________________________ U263EN-1.4
Enter the measured lower end current/voltage on channel 1.
Enter the measured upper end current/voltage on channel 1.
Connect the meter to the output of channel 2 and enter the
measured lower end current/voltage on channel 2.
Enter the measured upper end current/voltage on channel 2.
Using LED commands
If both the analogue outputs and humidity/temperature channels are
calibrated, the analogue outputs should be calibrated first. This applies
only when the calibrations are done using the LED commands!
connect an ammeter/voltmeter to the analogue outputs (connector
X2)
Disconnect the security lock jumper!
Give command ll.
the LED on the left flashes; set the low end of channel 1 with the
arrow keys and press ENT
the second LED from the left flashes; set the high end of channel 1
with the arrow keys and press ENT
Vista de pagina 69
1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 144 145

Comentarios a estos manuales

Sin comentarios