Vaisala WINDCAP WS425 Guía de usuario descargar pdf (Pagina 129)

Chapter 5 _________________________________________________________________ Operation

Data Messages

Depending on the settings, there are two modes in WMT700 for

sending data messages to the serial ports:

- Poll mode

- Automatic message mode

The data messages can contain measurement data calculated by

WMT700 and information on the status and properties of the

wind sensor.

For the Automatic message mode, you need to set the following

parameters:

- autoInt (defines the message send interval in seconds, 0.25 s

resolution)

- autoSend (0 = Automatic message mode disabled, for available

messages, see Table 40 on page 128.

- autoPort (defines where the message is sent: 1 = COM1,

2 = COM2)

When the WMT700 protocol is used, you can use either one of

the predefined message formats or user-configurable data

message format.

Table 40 on page 128 lists the data messages supported by

WMT700. The data message numbers in the table below are

needed when the WMT700 protocol POLL command is used or

the Automatic Message mode is used with any protocol.

VAISALA _______________________________________________________________________ 127

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 220 221

Sin comentarios

Vaisala WINDCAP WS425 Guía de usuario Pagina 129