Vaisala WMS302 Guía de usuario descargar pdf (Pagina 113)

Chapter 5 ________________________________________________________________ Operation

VAISALA______________________________________________________________________ 111

Quick Start Instructions

The quick start instructions in Table 9 on page 111 are based on the

following assumptions:

- You will use a default setup already loaded in MAWS.

- You have already assembled the MAWS system.

When taking MAWS into use for the first time or after connecting the

battery, make sure that the station-dependent settings are correct, see

section Using MAWS Terminal Software on page 113. For more

information about the commands, see Table 20 on page 156.

Table 9 Quick Start Instructions

Step Action Detailed Instruction

1. Connect power to MAWS. You can use the AC (mains) power

supply or the solar panel.

2. Establish terminal

connection with MAWS.

See section Establishing Terminal

Connection on page 112.

3. Start the MAWS Terminal

software.

See section Using MAWS Terminal

Software on page 113.

4. Set up station-dependent

settings for MAWS.

See section Modifying Station

Settings on page 125.

5. Test the setup. With the chosen setup loaded into

MAWS (see section MAWS Setup

File on page 135), check that you

start receiving reports and that

logging begins.

NOTE

Make sure that the battery is fully charged, and if not, charge the

battery before taking MAWS into use.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 261 262

Sin comentarios

Vaisala WMS302 Guía de usuario Pagina 113