Vaisala WMS302 Guía de usuario descargar pdf (Pagina 65)

Chapter 4 _______________________________________________________________ Installation

VAISALA_______________________________________________________________________ 63

7. Normally the tripod is fully assembled at the factory, but when not,

attach the leg fasteners (number 1 in Figure 45 on page 63) to the

upper base. Lock the leg (2) to the leg fastener with a bolt (3).

0201-027

Figure 45 Tripod's Leg Attachment

8. Attach the wind sensor adapter to the top of the wind/telescope

mast (if not already attached). Tighten with the small hex screw

(number 1 in Figure 46 on page 63). Guide the wind sensor cable

through the upper tube and connect it to the sensor. The sensor is

affixed into its place by tightening the plastic collar (2).

0201-023

Figure 46 Wind Sensor Adapter Attachment

9. Attach the sensor arm supports (number 1 in Figure 47 on page 64)

to the upper base. Tighten the screw properly with an appropriate

tool (2).

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 261 262

Sin comentarios

Vaisala WMS302 Guía de usuario Pagina 65