
Chapter 4 _______________________________________________________________ Installation
VAISALA_______________________________________________________________________ 85
2. Lead the cable (4) through the sensor arm (5). Guide the sensor
cable through the sensor arm opening (6).
3. After you have installed the sensor, connect the signal cable to the
applicable connector of the host unit.
Net Solar Radiation Sensor
Install the sensor to the sensor arm as follows:
1. Attach the mounting piece (1) to the sensor arm (2). Tighten with
the screws. For the numbers, see Figure 74 on page 85.
0506-049
Figure 74 Installing Net Solar Radiation Sensor
2. Attach the Net Solar Radiation Sensor (3) to the extension arm (4).
Attach the sensor's extension arm (4) to the mounting piece (1).
Tighten with the screws.
3. Lead the cable (5) through the sensor arm (2). Guide the sensor
cable through the sensor arm opening.
4. After you have installed the sensor, connect the signal cable to the
applicable connector of the logger.
Comentarios a estos manuales