Vaisala WMS302 Guía de usuario descargar pdf (Pagina 161)

Chapter 5 ________________________________________________________________ Operation

VAISALA______________________________________________________________________ 159

Disassembly of MAWS201 for Transportation

To disassemble the MAWS201 station for transportation, follow the

procedure below:

1. Disconnect the power as follows:

a. For short storage periods, set MAWS into low power

consumption mode by giving the command SLEEP in

MAWS Terminal.

b. For long periods (over one month), disconnect the battery.

First, open the hand screws that hold the tube in its place.

Open the logger housing. Detach the red wire from the +

terminal. Attach logger housing, lift the tube up and secure it

with the hand screws.

2. Remove the cables from the upper and lower base connectors.

3. Detach sensor arm(s). Insert the screws back in their places for

safekeeping.

4. Detach the telescope mast. Insert the screw back in its place for

safekeeping.

5. Remove wind sensor by opening the plastic collar. Detach wind

cable from the sensor.

6. Tilt the solar panel so that it is parallel to the tripod leg. Cover the

panel by an opaque cover or other material before electrical

connections to the modules or other system components are

handled.

7. Loosen the locking screw, put the legs together and tighten the

locking screw again.

Packing Instructions

For easy packing of the MAWS201 station, carry case sets are available

as options. For an example, see Figure 139 on page 160 and Figure 140

on page 160.

WARNING

Be careful when drawing the tripod legs together. See that there are no

power lines or other obstacles above the mast and the wind sensor.

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 261 262

Sin comentarios

Vaisala WMS302 Guía de usuario Pagina 161