
User's Guide ______________________________________________________________________
140 __________________________________________________________________M210630EN-B
may manually disable a measurement or a sensor. For detailed
information, see section Measurement Enable or Disable on page 140.
To see the logging groups, type logstatus. To see the current logging
status of a certain group, type logstatus <group_id>. To stop or start the
logging of a certain group, type logstop/loggo <group_id>. For the
output of the commands, see Figure 122 on page 140.
0312-068
Figure 122 Output of the Logstatus Command
Measurement Enable or Disable
You can manually enable or disable all measurement inputs and
sensors. You can use this feature, for example, for the following
purposes:
- Remotely changing the readings of a faulty sensor to be flagged as
invalid.
- Marking all sensor readings invalid during a maintenance
operation.
Comentarios a estos manuales