Vaisala WMS302 Guía de usuario descargar pdf (Pagina 159)

Chapter 5 ________________________________________________________________ Operation

VAISALA______________________________________________________________________ 157

logshowprev logshowprev <log_group_id> [count]. After the logshow command, can be

used to show the immediately preceding (earlier) log entries.

logstatus logstatus [log_group_id] shows logging state and variables of the defined

log group. The command without parameters shows statuses of all log

groups.

logstop logstop <log_group_id> stops logging of the defined log group.

md md <path> creates directory. E.g. md /Ext/logdata

move move <source file> <destination file> copies a file to another location and

removes the source file.

open Opens the terminal connection.

pslevel pslevel [meters]. To see the current pressure sensor level, type pslevel. To

change the pressure sensor level, type pslevel and the new pressure

sensor level in meters from the station altitude.

rd rd <path> removes directory

rep rep <report_name> shows contents of a report report_name. E.g. rep

MyRep0

reset reset [delay (seconds)] resets MAWS (warm boot). If the delay time is not

typed, MAWS resets immediately.

serial serial <port_number> [speed] [parity] [bits] [stop]. To see the settings of the

port number 0, type serial 0. To change the settings, type serial 0 and the

new parameters. E.g. serial 0 9600 N 8 1. Available ranges/options: Speed

300-19200, Parity N/O/E, Bits 7/8, Stop 0/1.

SLEEP Sets MAWS in low power-state. Use the SLEEP command to reduce power

consumption when storing the station for a few days (maximum period 1

month). Tip the spoon of the rain gauge to wake up MAWS. MAWS can also

be woken up by pressing the reset button. NOTE! The SLEEP command

must be written in upper case.

sname sname [station_name]. To see the current station name, type sname. To

change the name, type sname and the new name. If the station name

begins with a digit or contains a space, the name must be in quotes e.g.

sname Vaisala MAWS.

spclear spclear <parameter/ALL> clears a static parameter/all parameters.NOTE!

This command clears QMS101 and QMN101 sensitivity settings and is not

usually needed.

spset spset [parameter] [value] sets a value to a static parameter. To see a list of

static parameters, type spset. NOTE! This command is not usually needed.

SYSINFO SYSINFO gives information on the system. NOTE! The command must be

written in upper case.

time time [HH MM SS YY MM DD]. To see the current time, type time. To

change the current time, type time and the new time. E.g. time 14 10 00. To

change the current date, type time and the new time and date e.g. time 14

10 00 98 12 31.

timezone timezone [hours] sets the time difference from UTC. To see the time zone,

type timezone. To set the time zone, type e.g. timezone 2.

Table 20 Command Set (Continued)

Command Description

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 261 262

Vaisala WMS302 Guía de usuario Pagina 159

Comentarios a estos manuales

Vaisala WMS302 Guía de usuario Pagina 159

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control Vaisala WMS302